Hyundai Veloster Manuals

Hyundai Veloster: Care of seat belts - Seat belts - Safety features of your vehicleHyundai Veloster: Care of seat belts

Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse.

WARNING

When you return the rear seatback to its upright position after the rear seatback was folded down, be careful not to damage the seat belt webbing or buckle. Be sure that the webbing or buckle does not get caught or pinched in the rear seat. A seat belt with damaged webbing or buckle will not be as strong and could possibly fail during a collision or sudden stop, resulting in serious injury.

Periodic inspection

All seat belts should be inspected periodically for wear or damage of any kind. Any damaged parts should be replaced as soon as possible.

Keep belts clean and dry

Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not be used because they may damage and weaken the fabric.

When to replace seat belts

Entire in-use seat belt assembly or assemblies should be replaced if the vehicle has been involved in an accident. This should be done even if no damage is visible. Additional questions concerning seat belt operation should be directed to an authorized HYUNDAI dealer.

Seat belt precautions
WARNING All occupants of the vehicle must wear their seat belts at all times. Seat belts and child restraints reduce the risk of serious or fatal injuries for all occupants in the event of a coll ...

Child restraint system
Children riding in the car should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. According to accident s ...

See also:

DCT Control Modle (TCM) > Description and Operation
Description The Transmission Control Module (TCM) is like the brain for the DCT. It receives information from various sensors for a wide range of transmission controls to provide an optimal ...

Transmitter precautions
✽ NOTICE The transmitter will not work if any of following occur: • The ignition key is in ignition switch. • You exceed the operating distance limit (about 90 feet [30 m]). • Th ...

Master Cylinder. Components and Components Location
Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder assembly ...

Categories


© 2011-2024 Copyright www.hvmanual.com