Hyundai Veloster Manuals

Hyundai Veloster: Accelerator Pedal. Repair procedures - Fuel Delivery System - Fuel SystemHyundai Veloster: Accelerator Pedal. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Fuel Delivery System / Accelerator Pedal. Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation bolt (B) and nuts (C), and then remove the accelerator pedal module.


Installation

1.
Installation is reverse of removal.
Accelerator pedal module installation nut:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Filler-Neck Assembly. Repair procedures
Removal 1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler ...

Delivery Pipe. Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be in ...

See also:

Input Speed Sensor 2 > Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Remove the under cover. 2. Disconnect the inp ...

Specifications
Specification Engine TM Joint type Max. permissible angle Outer Inner Outer Inner Ga ...

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...

Categories

В© 2011-2026 Copyright www.hvmanual.com