Hyundai Veloster Manuals

Hyundai Veloster: Specifications - Multifunction switch - Body Electrical System - Hyundai Veloster 2010-2019 Service ManualHyundai Veloster: Specifications

Specifications

Items
Specifications
Rated voltage
DC 12V
Operating temperature range
-30°C ~ +80°C (-22 ~ +176°F)
Rated load
Dimmer & passing switch
High : 1.0A (Relay load)
Low : 1.0A (Relay load)
Passing : 1.0A (Relay load)
Lighting switch
Lighting : 1.0A (Relay load)
Turn signal & lane change switch
6.6 ± 0.5A (Lamp load)
Fog lamp switch(Front & Rear)
1.0A (Relay load)
Wiper & mist switch
Low, High : 4.0A (Motor load)
Intermittent : 0.22 ± 0.05A (Relay load)
Lock : Max. 28A (Motor load)
Mist : 4.0A (Motor load)
Washer switch(Front & Rear)
4A (Motor load)
Rear Wiper
0.2A (Relay load)


Multifunction switch
...

Components and Components Location
Components(1) Connector name No Descripton Connector name No RH SIDE Lighting (13 pin) -LH side ...

See also:

Front Hub / Knuckle. Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel an ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door delta inner cover 3. Rear door inside handle cap 4. Rear door trim seal 5. Rear door panel assembly 6. Rear door be ...

Anchor Pretensioner (APT). Description and Operation
Description Front anchor pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver se ...

Categories

© 2011-2019 Copyright www.hvmanual.com