Hyundai Veloster: Meaning Of Symbols

There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service.

Tightening Torque Table Of Standard Parts

Bolt nominal diameter (mm) Pitch (mm) Torque Nm (kg.cm, lb.ft) Head Mark 4 Head Mark 7 ...

General Service Information

Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod m ...

See also:

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body ...

Under Body. Body Repair
Projected Dimensions Front side member tooling hole (Ø6.6) Front side member tooling hole (Ø6.6) ...