Hyundai Veloster: Electrical System
Hyundai Veloster 2011-2017 Service Manual / General Information / Electrical System
Hyundai Veloster 2011-2017 Service Manual / General Information / Electrical System
| 1. |
Be sure to disconnect the battery cable from the negative (-)
terminal of the battery.
|
| 2. |
Never pull on the wires when disconnecting connectors.
|
| 3. |
Locking connectors will click when the connector is secure.
|
| 4. |
Handle sensors and relays carefully. Be careful not to drop them
against other parts.
|
Parts
When replacing parts, use HYUNDAI genuine parts.
Replacement
Standard values, such as torques and certain adjustments, must be strictly
observed in the reassembly of all parts.
If r ...
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or tubing.
...
See also:
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
store ...
Auto Light Sensor. Repair procedures
Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto ligh ...
Manifold Absolute Pressure Sensor (MAPS). Schematic Diagrams
Circuit Diagram
...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
© 2011-2026 Copyright www.hvmanual.com