Hyundai Veloster Manuals

Hyundai Veloster: Description and Operation - Ignition System - Engine Electrical SystemHyundai Veloster: Description and Operation

Descrition

Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The ignition coil is activated, and timing is controlled.

Ignition System
...

Repair procedures
On-vehicle Inspection Spark Test 1. Remove the engine cover (A). 2. Disconnect the ignition coil connectors (A). ...

See also:

Auto Light Sensor. Repair procedures
Inspection In the state of IGN1 ON, when multifunction switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto ligh ...

Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower ar ...

Fuel Tank Pressure Sensor (FTPS). Specifications
Specification Pressure [kPa (kgf/cm², in H2O) Output Voltage (V) -6.67 (-0.068, -26.8) 0.5 0 2.5 ...

Categories

В© 2011-2026 Copyright www.hvmanual.com