Troubleshooting
Symptom |
Suspect Area |
Remedy |
Water leaks from panoramaroof |
Deteriorated roof lid weatherstrip |
Replace |
Excessive roof lid-to-body clearance and Improperly fitted
weatherstrip |
Adjust |
|
Wind noise around panoramaroof |
Loose or deformed deflector, gapsIn body work |
Retighten adjust or replace |
Noise heard when opening/ closing panoramaroof |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
Loose guide rails and lid |
Retighten |
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
Incorrect engagement of motor pinion with drive cable |
||
Decrease in motor`s clutch slipping force |
||
Increased sunroof sliding resistance or interference
of sunroof with drive cables, weatherstrip, etc. due to maladjustment of
sunroof |
||
Noise in motor (clutch slipping noise from motor when
sunroof is fully opened or closed is not an unusual noise |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and retighten motor |
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
Worn out or deformed drive cable |
Replace |
|
Door glass fails to operate Up and Down |
Incorrect window glass installation |
Adjust position |
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
Defective door check assembly |
Correct or replace |
|
Door hinge requires grease |
Apply grease |
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
Incorrectly installed hood |
Adjust |
|
Incorrect hood bumper height |
Adjust |
|
Water leak through windshield and rear window |
Defective seal |
Fill with sealant |
Defective flange |
Correct |
To connect using the unit settings (2)
1. Press on the control panel.
2. Press [Search for Bluetooth devices].
NOTE:
If you touch on the control panel
again after connected via Bluetooth wireless technology, the Bluetooth main scr ...
CVVT (Continuously Variable Valve Timing) System. Description and Operation
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated ...
To connect using the phone settings
Your phone's Bluetooth feature may be set to off by default. To use the Bluetooth
feature, Bluetooth must be turned on in your phone. Refer to your phone's user guide.
1. Enable the phone ...