Hyundai Veloster: Side Airbag (SAB) Module. Repair procedures
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
|
| 1. |
Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
|
| 2. |
Remove the front seat assembly.
(Refer to the Body group - "Seat")
|
| 3. |
Remove the seat back assembly.
(Refer to the Body group - "Seat")
|
Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
| 3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
| 4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
| 5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the side airbag (SAB), confirm proper system
operation:
|
Side Airbag (SAB) Module. Components and Components Location
Curtain Airbag (CAB) Module. Description and OperationRepair procedures
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn ...
Rear combination light bulb replacement
(1) Stop and tail light (2) Back-up light (3) Rear turn signal light (4)
Tail light
Outside
1. Open the tailgate. 2. Loosen the outside light assembly retaining screws
with a cross-tip screw ...
Driver Airbag (DAB) Module and Clock Spring. Description and Operation
Description
Driver Airbag (DAB) is installed in the steering wheel and electrically
connected to SRSCM via the clock spring. It protects the driver by deploying
the airbag when frontal crash ...