Hyundai Veloster: Setting the tire inflation pressure
12. After driving approximately 2 miles (3 km), stop at a suitable location.
13. Connect connection hose (9) of the compressor directly to the tire valve.
14. Connect between compressor and the vehicle power outlet using the cable and
connectors.
15. Adjust the tire inflation pressure to 32 psi (220 kPa). With the
ignition switched on, proceed as follows.
- To increase the inflation pressure:
Switch on the compressor, position I. To check the current inflation pressure setting,
briefly switch off the compressor.
WARNING
Do not let the compressor run for more than 10 minutes, otherwise the device will overheat and may be damaged.
✽ NOTE
The pressure gauge may show higher than actual reading when the compressor is running. To get an accurate tire reading, the compressor needs to be turned off.
- To reduce the inflation pressure:
Press the button (8) on the compressor.
CAUTION
Be careful not to overinflate the tire and stay away from the tire when filling it.
16. Remove the speed restriction label(0) from the sealant bottle(1) and place it in a highly visible place in the vehicle such as on the steering wheel to remind you not to drive too fast.
CAUTION
If the inflation pressure is not maintained, drive the vehicle a second time, refer to Distributing the sealant. Then repeat steps 1 to 4.
Use of the Tire Mobility Kit may be ineffectual for tire damage larger than approximately 0.16 in (4 mm).
Please contact the nearest HYUNDAI dealer if the tire cannot be made roadworthy with the Tire Mobility Kit.
WARNING
The tire inflation pressure must be at least 32 psi (220 kPa). If it is not, do not continue driving. Call for road side service or towing.
Using the Tire Mobility Kit
Technical DataSpecial Service Tools
Special Service Tools
Tool (Number and Name)
Illustration
Use
09561-11001
Steering wheel puller
Remove the steering ...
Roof Trim. Components and Components
Location
Components
[General Type]
1. Roof trim
2. Retainer
3. Sunvisor
4. Assist handle
5. Assist handle bracket assembly
6. Garment hook assembly
7. ...
Clutch Pedal. Repair procedures
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floor board) and the clutch pedal clevis pin pla ...