Inspection
1. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
2. |
Measure the distance the steering wheel can be turned without
moving the front wheels.
|
3. |
If the play exceeds standard value, inspect the steering column,
shaft, and linkages.
|
1. |
Position the vehicle on a level surface and place the steering
wheel in the straight ahead position.
|
2. |
Start the engine and turn the steering wheel from lock to lock
several times to warm up the power steering fluid.
|
3. |
Attach a spring scale to the steering wheel. With the engine speed
900 ~ 1100rpm, pull the scale and read it as soon as the tires begin
to turn.
|
4. |
If the measured value exceeds standard value, inspect the power
steering gear box and EPS system.
|
Input Speed Sensor 2 > Repair procedures
Inspection
Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.
Removal
1.
Remove the under cover.
2.
Disconnect the inp ...
Clutch Actuator Motor 2 (Even Gear) > Repair procedures
Inspection
1.
Turn off the ignition switch.
2.
Disconnect the clutch motor connector.
3.
Measure the resista ...
Injector. Schematic Diagrams
Circuit Diagram
...