Hyundai Veloster: Passive Occupant Detection System (PODS-F). Description and Operation

In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passive occupant detection system (PODS-F). If the seat is occupied, PODS-F detects passenger presences status and send signal to SRSCM via CAN.

SRSCM recognizes the signal as 2(two) different classifications; that is, 1(Empty or small occupant with child restraint system), 2(Occupied with large occupant and small occupant).

With these signal, ACU determines whether it needs to deploy PAB(Passenger Airbag) or not.

Seat Belt Buckle Switch (BS). Repair procedures

Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat asse ...

Passive Occupant Detection System (PODS-F). Components and Components Location

Components ...

See also:

To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it ...

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

Troubleshooting
Troubleshooting Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetoot ...