Hyundai Veloster: Manifold Absolute Pressure Sensor (MAPS). Description and Operation

Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calculates the intake air quantity and engine speed.

The MAPS consists of a piezo-electric element and a hybrid IC amplifying the element output signal. The element is silicon diaphragm type and adapts pressure sensitive variable resistor effect of semi-conductor. Because 100% vacuum and the manifold pressure apply to both sides of the sensor respectively, this sensor can output analog signal by using the silicon variation proportional to pressure change.

ETC (Electronic Throttle Control) System. Repair procedures

Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output ...

Manifold Absolute Pressure Sensor (MAPS). Specifications

Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 ...

See also:

TPMS Receiver. Repair procedures
Replacement When the receiver first arrives for replacement: 1) It will be in Virgin State. ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door delta inner cover 3. Rear door inside handle cap 4. Rear door trim seal 5. Rear door panel assembly 6. Rear door be ...

Front Washer Motor. Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...