Hyundai Veloster Manuals

Hyundai Veloster: High Mounted stop lamp. Repair procedures - Lighting System - Body Electrical SystemHyundai Veloster: High Mounted stop lamp. Repair procedures

Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove the tailgate center trim.
(Refer to the BD group - "Exterior - Tailgate")
3.
Loosen 4 nuts and remove the rear garnish assembly after disconnecting the connector.
4.
Loosen 5 screws and remove the garnish cover (A).

5.
Loosen 4 screws and remove the high mounted stop lamp (A).


Installation

1.
Install the high mounted stop lamp.
2.
Install the rear garnish and the tailgate trim.

Fog Lamps. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lighting switch of the multifunction switch. (Refer to the &q ...

Rear combination lamp. Repair procedures
Removal Rear Combination lamp 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after loosening 2 screws, an ...

See also:

Concentric Slave Cylinder Assembly. Components and Components Location
Component 1. Concentric slave cylinder assembly 2. Manual transaxle ...

ESC Control Module. Components and Components Location
Components 1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module (HECU) 8. Damper ...

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Categories

В© 2011-2026 Copyright www.hvmanual.com