Hyundai Veloster: Heated Oxygen Sensor (HO2S). Specifications
Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S). Specifications
Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S). Specifications
Specification
HO2S [Bank 1/Sensor 1]
|
Item |
Specification |
|
Heater Resistance (Ω) |
2.4 ~ 4.0 [20°C(68°F)] |
HO2S [Bank 1/Sensor 2]
|
A/F Ratio (λ) |
Output Voltage(V) |
|
RICH |
0.6 ~ 1.0 |
|
LEAN |
0 ~ 0.4 |
|
Item |
Specification |
|
Heater Resistance (Ω) |
Approx. 9.0 [21°C(69.8°F)] |
Heated Oxygen Sensor (HO2S). Description and Operation
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Manifold Catalytic Converter. The sensor
output voltage varies ...
Heated Oxygen Sensor (HO2S). Troubleshooting
Signal Waveform
...
See also:
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when ...
Ignition switch position
LOCK
The steering wheel locks to protect against theft (if equipped). The ignition
key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the k ...
Antenna Coil. Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad& ...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
© 2011-2026 Copyright www.hvmanual.com