Hyundai Veloster Manuals

Hyundai Veloster: Fuel Tank Air Filter. Repair procedures - Evaporative Emission Control System - Emission Control SystemHyundai Veloster: Fuel Tank Air Filter. Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve.
5.
Remove the fuel tank air filter assembly after removing bolts (C).

6.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.


Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Installation is reverse of removal.

Fuel Filler Cap. Description and Operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

Exhaust Emission Control System
...

See also:

Concentric Slave Cylinder Assembly. Repair procedures
Removal 1. Remove the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle") 2. Remove the concentric ...

Double clutch transmission operation
The automatic transaxle has 6 forward speeds and one reverse speed. The individual speeds are selected automatically, depending on the position of the shift lever. ✽ NOTICE The first few sh ...

Clutch Pedal. Repair procedures
Inspection Clutch Pedal Inspection 1. Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin pla ...

Categories

© 2011-2026 Copyright www.hvmanual.com