Hyundai Veloster Manuals

Hyundai Veloster: Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Veloster: Front Impact Sensor (FIS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Advanced) / SRSCM / Front Impact Sensor (FIS). Repair procedures

Removal

•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front wheel guard.
3.
Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
4.
Remove the front impact sensor mounting bolt (B).
5.
Disconnect the front impact sensor connector (A).
6.
Remove the front impact sensor.

Installation

•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
5.
Install the front wheel guard.
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS). Components and Components Location
Components ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

See also:

Airbag Module Disposal. Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbag ...

Main components of occupant classification system
A detection device located within the front passenger seat frame. Electronic system to determine whether the front passenger air bag system should be activated or deactivated. A warning ligh ...

Knock Sensor (KS). Specifications
Specification Item Specification Capacitance (pF) 950 ~ 1,350 Resistance (MΩ) 4.87 ...

Categories

© 2011-2026 Copyright www.hvmanual.com