Hyundai Veloster Manuals

Hyundai Veloster: Filler-Neck Assembly. Repair procedures - Fuel Delivery System - Fuel SystemHyundai Veloster: Filler-Neck Assembly. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Fuel Delivery System / Filler-Neck Assembly. Repair procedures

Removal

1.
Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A).

2.
Disconnect the fuel filler hose (A) and the ventilation hose (B).
3.
Remove the filler-neck assembly from the vehicle after removing the bracket mounting bolt (C).


Installation

1.
Installation is reverse of removal.

Filler-neck assembly bracket installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Filler-neck assembly installation screw :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)


Fuel Filter. Repair procedures
Replacement 1. Remove the fuel pump (Refer to “Fuel Pump� in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel ...

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor conn ...

See also:

Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

Wheel nut tightening torque
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m) If you have a tire gauge, remove the valve cap and check the air pressure. If the pressure is lower than recommended, drive slowly ...

Changing tires
1. Park on a level surface and apply the parking brake firmly. 2. Shift the shift lever into R (Reverse) with manual transaxle or P (Park) with automatic transaxle. 3. Activate the hazard warnin ...

Categories

© 2011-2026 Copyright www.hvmanual.com