Hyundai Veloster: Battery replacement
Hyundai Veloster 2011-2017 Owner's Manual / Features of your vehicle / Remote keyless entry / Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gently pry open the transmitter center
cover.
2. Replace the battery with a new battery (CR2032). When replacing the
battery, make sure the battery positive “+” symbol faces up.
3. Install the battery
in the reverse order of removal.
For replacement transmitters, see an authorized HYUNDAI dealer for transmitter reprogramming.
CAUTION
- • The transmitter is designed to give you years of trouble-free use, however it can malfunction if exposed to moisture or static electricity. If you are unsure how to use your transmitter or replace the battery, contact an authorized HYUNDAI dealer.
- • Using the wrong battery can cause the transmitter to malfunction. Be sure to use the correct battery.
- • To avoid damaging the transmitter, don't drop it, get it wet, or expose it to heat or sunlight.
WARNING
An inappropriately disposed
battery can be harmful to the environment and human health.
Dispose the battery according to your local law(s) or regulation.
Transmitter precautions
✽ NOTICE
The transmitter will not work if any of following occur:
• The ignition key is in ignition switch.
• You exceed the operating distance limit (about 90 feet [30 m]).
• Th ...
Theft-alarm system
This system is designed to provide protection from unauthorized entry into the
vehicle. This system is operated in three stages: the first is the "Armed" stage,
the second is the " ...
See also:
Consumer information
This consumer information has been prepared in accordance with regulations issued
by the National Highway Traffic Safety Administration of the U.S. Department of
Transportation. Your Hyundai deale ...
Glove box
To open the glove box, push the button and the glove box will automatically open.
Close the glove box after use.
WARNING
To reduce the risk of injury in an accident or sudden stop, always keep t ...
Knock Sensor (KS). Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the intake manifold (Refer to “Intake ...