Hyundai Veloster: Antenna Coil. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Disconnect the 6P connector (B) after loosening the screw and
then remove the antenna coil (A).
|
Installation
| 1. |
Install the antenna coil.
|
| 2. |
Connect the antenna coil connector.
|
| 3. |
Install the crash pad lower panel.
|
Immobilizer Control Unit. Repair proceduresDescription and Operation
Limitations Of The Navigation system
GPS Signal Reception State
As the GPS satellite frequency is received/transmitted in straight lines,
reception may not work if hiding devices are placed ...
Clutch Pedal. Repair procedures
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floor board) and the clutch pedal clevis pin pla ...
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling� while the vehicle is in motion,
store ...