Hyundai Veloster Manuals

Hyundai Veloster: Yaw-rate and Lateral G Sensor. Description and Operation - ESC(Electronic Stability Control) System - Brake SystemHyundai Veloster: Yaw-rate and Lateral G Sensor. Description and Operation

Hyundai Veloster 2011-2017 Service Manual / Brake System / ESC(Electronic Stability Control) System / Yaw-rate and Lateral G Sensor. Description and Operation

Description

When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor.
If yaw velocity reaches the specific velocity after it detects the vehicle'yawing, the ESC control is reactivated.
The later G sensor senses vehicle's lateral G. A small element inside the sensor is attached to a deflectable leverarm by later G.
Direction and magnitude of lateral G loaded to vehicle can be known with electrostatic capacity changing according to lateral G.
The longitudinal G sensor is installed in the yaw-rate sensor.
This longitudinal G sensor detects vertical acceleration of the vehicle, while the lateral G sensor detects lateral acceleration of the vehicle. The HECU uses these signals for the Hill start Assist Control function.

Specifications
Description
Specification
Remarks
Operating voltage
10 ~ 16V

Output signal
CAN Interface

Operating temperature
-40 ~ 85°C (-40 ~ 185°F)

Yaw-rate sensor
Measurement range
-75 ~ 75°/sec

Frequency response
15 ~ 45Hz

G sensor
(Lateral / Longitudinal)
Measurement range
-14.715 ~ +14.715g

Frequency response
50Hz ± 60%


External Diagram


Rear Wheel Speed Sensor. Repair procedures
Removal 1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Yaw-rate and Lateral G Sensor. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the passenger seat assembly. (Refer ...

See also:

Fuel Pump. Repair procedures
Removal 1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove th ...

Troubleshooting
Troubleshooting 1. The lamp switch inputs can be checked using the GDS. 2. To check the input value of lamp switch, select option "IPM&quo ...

Audio system
✽ NOTICE If you install an after market HID (high intensity discharge) head lamp, your vehicle's audio and electronic device may malfunction. ...

Categories


© 2011-2024 Copyright www.hvmanual.com