Hyundai Veloster: Variable Intake Solenoid (VIS) Valve. Description and Operation
Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Description and Operation
Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Description and Operation
Description
Variable Intake manifold Solenoid (VIS) valve is installed on the intake
manifold. The VIS valve controls the vacuum modulator which activates a valve
in the intake manifold. The ECM opens or closes this valve according to engine
condition (Refer to below table).
|
Engine condition |
VIS valve |
Operation |
|
Medium speed |
Closed |
Increasing engine performance in low engine speed by reducing intake
interference among cylinders |
|
Low / High speed |
Open |
Minimizing intake resistance by shortening intake manifold length
and increasing area of air entrance |
CVVT Oil Control Valve (OCV). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the ...
Variable Intake Solenoid (VIS) Valve. Specifications
Specification
Item
Specification
Coil resistance (Ω)
30.0 ~ 35.0 [20°C(68°F)]
...
See also:
Panoramaroof Motor. Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim.
(Refer to the BD group - "Roof trim")
...
Troubleshooting
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetoot ...
ETC (Electronic Throttle Control) System. Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output ...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
© 2011-2024 Copyright www.hvmanual.com