Hyundai Veloster Manuals

Hyundai Veloster: Troubleshooting - Tire Pressure Monitoring System - Suspension SystemHyundai Veloster: Troubleshooting

System self diagnosis

Possible to detect abnormal situations from Sensor data

•
High Temperature – Sensor's temperature is more than 100 °C
•
Battery Low – Sensor's battery is less than 2.1v
•
Sensor Failure

ECU can be detected any abnormal situation by the periodic inspection

•
Auto Learning Failure – 4 ID not learn in 19 minutes
•
Sensor Mute Failure - Not received frame for 17 minutes
•
RF IC Failure - 4 sensor mute DTC occurred and RF IC not respond
•
ECU Under/Over voltage – IG_ON < 9V for 2 sec or IG_ON. 16V for 2sec
•
EEPROM Failure – EEPROM IC not respond or CRC Check error
•
CAN Bus Failure

Warning Condition

•
Low Pressure

Schematic Diagrams
System circuit diagram Connector pin number Pin No. Discription Remark 1 IG ON   ...

TPMS Sensor. Description and Operation
Description Function 1. Tire pressure, Temperature, Acceleration, Battery voltage measurement 2. RF (Radio Frequency) Transmit (Tire ...

See also:

Good driving practices
Never take the vehicle out of gear and coast down a hill. This is extremely hazardous. Always leave the vehicle in gear. Do not "ride" the brakes. This can cause them to overheat and ...

Manifold Absolute Pressure Sensor (MAPS). Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 ...

GPS Antenna. Repair procedures
Removal Roof Antenna (GPS) 1. Remove the rear roof trim. (Refer to the BD group - "Roof trim") 2. Disconnect the cables ( ...

Categories

© 2011-2026 Copyright www.hvmanual.com