Removal
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Remove the floor console.
(Refer to the Body group - "Console")
|
4. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A and B).
|
5. |
Remove the SRSCM mounting bolt and nuts from the SRSCM, then remove
the SRSCM.
|
Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Install the SRSCM with the SRSCM mounting bolt and nuts.
|
4. |
Connect the SRSCM harness connector.
|
5. |
Install the floor console.
(Refer to the Body group - "Console")
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the SRSCM, confirm proper system operation:
|
Variant coding
|
■ On-Line type on GDS |
1. |
Ignition "OFF", connect GDS.
|
2. |
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
|
3. |
Select Variant coding mode.
|
4. |
Follow steps on the screen as below.
|
1) This screen is opened when you try the variant coding again
on the SRSCM which has bee performed variant coding.
2) Screen of communication failure
|
1) This screen is opened when you try the variant coding again
on the SRSCM which has bee performed variant coding.
|
Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver se ...
Panoramaroof. Repair procedures
Replacements
Movable glass Replacement
1.
Open the movable glass fully.
2.
After loosening the mounting screws, then remove
the movabl ...
Repair procedures
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn ...