Hyundai Veloster Manuals

Hyundai Veloster: SRS Control Module (SRSCM). Description and Operation - SRSCM - Restraint (Depowered)Hyundai Veloster: SRS Control Module (SRSCM). Description and Operation

Hyundai Veloster 2011-2017 Service Manual / Restraint (Depowered) / SRSCM / SRS Control Module (SRSCM). Description and Operation

Description

The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint system or not. After determining that pretensioners and/or airbag deployment is required, the SRSCM must supply sufficient power to the pretensioners and airbag igniters to initiate deployment.
The SRSCM determines that an impact may require deployment of the pretensioners and airbags from data obtained from impact sensors and other components in conjunction with a safing function.
The SRSCM will not be ready to detect a crash or to activate the restraint system devices until the signals in the SRSCM circuitry stabilize.
It is possible that the SRSCM could activate the safety restraint devices in approximately 3 seconds but is guaranteed to fully function after prove-out is completed.
The SRSCM must perform a diagnostic routine and light a system readiness indicator at key-on. The system must perform a continuous diagnostic routine and provide fault annunciation through a warning lamp indicator in the event of fault detection. A serial diagnostic communication interface will be used to facilitate servicing of the restraint control system.

SRSCM
...

SRS Control Module (SRSCM). Components and Components Location
Components ...

See also:

Aux, USB and iPod® port
If your vehicle has an aux and/or USB(universal serial bus) port or iPod port, you can use an aux port to connect audio devices and a USB port to plug in a USB, or use the HYUNDAI accessory ipod ...

Operating door locks from inside the vehicle
With the door lock button To unlock a door, push the door lock button (1) to the “Unlock” position. The red mark (2) on the button will be visible. To lock a door, push the door lock bu ...

Passive Occupant Detection System (PODS-F). Repair procedures
Removal PODS-F ECU 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the ...

Categories


© 2011-2024 Copyright www.hvmanual.com