Hyundai Veloster Manuals

Hyundai Veloster: Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Veloster: Side Impact Sensor (SIS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Depowered) / SRSCM / Side Impact Sensor (SIS). Repair procedures

Removal

Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
3.
Remove the center pillar lower trim.
(Refer to the Body group - "Interior trim")
4.
Disconnect the side impact sensor connector (A).
5.
Loosen the side impact sensor mounting bolt (B) and remove the side impact sensor.

Installation

Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt then connect the side impact sensor connector.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
2.
Install the center pillar lower trim.
(Refer to the Body group - "Interior trim")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Impact Sensor (SIS). Components and Components Location
Components ...

Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) SRSCM Connector terminal Pin Function (Connector A) Pin Function (Connector B) ...

See also:

Power Door Lock Actuators. Repair procedures
Inspection Front Door Lock Actuator Inspection 1. Remove the front door trim. (Refer to the BD group - "Front door") 2. R ...

Input Speed Sensor 2 > Description and Operation
Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the TCM. It provides important input information for electric contr ...

Front Wiper Motor. Repair procedures
Removal 1. Remove the passenger cowl top cover (A) to remove passenger wiper blade. 2. Loosen the windshield wiper arm nut (B) aft ...

Categories


В© 2011-2024 Copyright www.hvmanual.com