Hyundai Veloster Manuals

Hyundai Veloster: Side Airbag (SAB) Module. Repair procedures - Airbag Module - Restraint (Depowered)Hyundai Veloster: Side Airbag (SAB) Module. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Depowered) / Airbag Module / Side Airbag (SAB) Module. Repair procedures

Removal

The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to the Body group - "Seat")
3.
Remove the seat back assembly.
(Refer to the Body group - "Seat")

Installation

Be sure to install the harness wires not to be pinched or interfered with other parts.
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the new seat back assembly.
(Refer to the Body group - "Seat")
4.
Install the front seat assembly.
(Refer to the Body group - "Seat")
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Airbag (SAB) Module. Components and Components Location
Components ...

Curtain Airbag (CAB) Module. Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain ...

See also:

High mounted stop light replacement
If the light does not operate, have the vehicle checked by an authorized HYUNDAI dealer. 3. Loosen the assembly retaining nuts. 4. Remove the rear combination light assembly from the body of th ...

Side Impact Sensor (SIS). Repair procedures
Removal Side Impact Sensor 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remo ...

Special Service Tools
Special Service Tools Item Illustration Application Fuel Pressure Gauge (09353-24100) Measuring the fuel line press ...

Categories


© 2011-2024 Copyright www.hvmanual.com