Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad center fascia panel (A).
|
3. |
Remove the driver and the assist seat heater switch connector,
after loosening 4 screws.
|
Installation
1. |
Install th driver and the assist seat heater switch connector.
|
2. |
Install the crash pad ceter fascia panel.
|
3. |
Connect the battery (-) terminal.
|
Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad center fascia panel.
|
3. |
Disconnector the driver and the assist seat heater switch connector.
|
4. |
Turn rear seat heater switch ON and check that continuity exists
between the terminals.
|
5. |
If there is no continuity, replace the seat heater switch.
|
Description and Operation
System Overview
RPAS(Rear Parking Assist System) is an electronic driving aid device warning
driver to be cautious during parking or low speed when after detecting an object
on side and behi ...
Rear Hub - Carrier. Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and ...
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, ...