Hyundai Veloster Manuals

Hyundai Veloster: Seat Belt Pretensioner (BPT). Repair procedures - Seat Belt Pretensioner - Restraint (Depowered)Hyundai Veloster: Seat Belt Pretensioner (BPT). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Depowered) / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT). Repair procedures

Removal

1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the lower anchor bolt.
3.
Remove the following parts.
(Refer to the Body group - "Interior trim")
A.
Door scuff trim
B.
Center pillar trim
4.
Remove the upper anchor bolt.
5.
Disconnect the seat belt pretensioner connector (A).

6.
Loosen the seat belt pretensioner mounting bolts (B,C) and remove the seat belt pretensioner.

Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with a bolts (B, C).

Tightening torque [Bolt B]:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (A).
5.
Install the upper anchor bolts.

Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.
Install the following parts.
(Refer to the Body group - "Interior trim")
A.
Center pillar trim
B.
Door scuff trim
7.
Install the lower anchor bolts.

Tightening torque:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

8.
Reconnect the battery negative cable.
9.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Seat Belt Pretensioner (BPT). Components and Components Location
Components ...

Brake System
...

See also:

Tire. Repair procedures
• Using tires and wheel other than the recommended sizes could cause unusual handling charact ...

Vanity mirror lamp
Push the switch to turn the light on or off. • : The lamp will turn on if this button is pressed. • : The lamp will turn off if this button is pressed. CAUTION - Vanity mirror lamp (if equ ...

To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when you move the lever ...

Categories


© 2011-2024 Copyright www.hvmanual.com