Inspection
1. |
Remove the front door trim.
(Refer to the BD group - "Front door")
|
2. |
Remove the front door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate trim panel.
(Refer to the BD group - "Tailgate")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Remove the front door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Remove the tailgate trim.
(Refer to the BD group - "Tailgate")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Disconnect the connector from the hood switch (A).
|
2. |
Check for continuity between the terminals and ground according
to the table.
|
1. |
Remove the burglar horn (A) after removing 1 bolt and disconnect
the 2P connector from the burglar horn.
|
2. |
Test the burglar horn by connecting battery power to the terminal
1 and ground the terminal 2.
|
3. |
The burglar horn should make a sound. If the burglar horn fails
to make a sound replace it.
|
Shift Lever > Repair procedures
Removal
1.
Remove the floor console assembly.
(Refer to the Interior (Console) of BD Group.)
2.
Disconnect the sports mode connector (A ...
Smart key. Repair procedures
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector in driver
side crash pad lower panel, turn the power on GDS.
...
Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
...