Inspection
1. |
Remove the horn relay (A) from the engine room relay box.
|
2. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Removal
1. |
Remove the mounting bolt and disconnect the horn connector (B),
then remove the horn (A).
|
Installation
1. |
Connect the horn connector, then reassemble the horn.
|
Adjustment
After adjustment, apply a small amount of paint around the screw
head to keep it from loosening.
|
Curtain Airbag (CAB) Module. Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
2.
Remove the roof trim.
...
Rear Washer Switch. Repair procedures
Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and washer switch.
Rear Wiper Switch
...
Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver se ...