Inspection
Inspection (With GDS)
1. |
Check BCM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
|
2. |
If diagnosis is required on the multifunction switch, select model
and "BCM".
|
3. |
To consult the present input/output value of BCM, "Current DATA".
It provides information of BCM input/output conditions of power supply,
turn signal/brake lamp, headlamp, door, locks, outside mirror, wiper,
auto-light and transmitters etc.
|
4. |
To perform compulsory operation on BCM input factors, select "ACTUATION
TEST".
|
Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
3. |
Remove the steering column upper and lower shrouds.
|
4. |
Remove the clock spring.
|
5. |
Disconnect the lighting switch connector and wiper & washer switch
connector.
|
6. |
Remove the multifunction switch assembly(A) with loosening 2 screws.
|
7. |
If it is necessary to remove. The wiper & washer switch only,
release the lock of wiper switch using tool without removing the steering
wheel and the clock spring.
|
Installation
1. |
Install the multifunction switch.
|
2. |
Install the clock spring.
|
3. |
Install the steering column upper and lower shrouds.
|
4. |
Install the steering wheel.
|
Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions
only for the maintenance items that are easy to perform.
As explained earlier in this section, several procedu ...
Schematic Diagrams
Circuit Diagram
...
Panoramaroof. Repair procedures
Replacements
Movable glass Replacement
1.
Open the movable glass fully.
2.
After loosening the mounting screws, then remove
the movabl ...