Hyundai Veloster Manuals

Hyundai Veloster: Repair procedures - Manual Transaxle System - Manual Transaxle System (M6CF1)Hyundai Veloster: Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Manual Transaxle System (M6CF1) / Manual Transaxle System / Repair procedures

Inspection

Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil filler plug (A) with a new washer.
3.
Check level with finger.
Oil level must be up to fill the hole, if not, add oil until it runs over.

4.
Install the filler plug with a new gasket.
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)
Manual Transaxle Oil Replacement
1.
Park the vehicle on a level ground and stop the engine.
2.
Drain the manual transaxle oil after loosening the drain plug (A).
3.
Intall the drain plug with a new gasket
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)
4.
Add new oil through the filler plug hole and, fill it just below the plug opening.
Standard oil: SAE 75W/85, API GL-4
Oil capacity: 1.8 ~ 1.9L (0.48 ~ 0.50 U.S.gal., 1.90 ~ 2.01 U.S. qt., 1.58 ~ 1.67 lmp qt.)

Manual Transaxle System
...

Manual Transaxle. Components and Components Location
Components 1. Transaxle support bracket 2. Control shaft complete 3. Back up lamp switch 4. Speedmeter ...

See also:

Accelerator Position Sensor (APS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. To improve the effectiveness of heating and cooling : - Heating: - Cooling: 3. Set the temperature control to the desired position. ...

Front Impact Sensor (FIS). Components and Components Location
Components ...

Categories

В© 2011-2026 Copyright www.hvmanual.com