Inspection
[System Inspection]
1. |
Disconnect the vapor hose from the intake manifold and connect
a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]
|
2. |
Check the following points with applied vacuum at the purge control
solenoid valve (PCSV).
· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]
|
[PCSV Inspection]
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the PCSV connector (A).
|
3. |
Disconnect the vapor hose (B) which is connected to the intake
manifold from the PCSV.
|
4. |
After connecting a vacuum pump to the nipple, apply vacuum.
|
5. |
With the PCSV control line grounded, check the valve operation
with battery voltage applied to the PCSV(Open) and removed(Closed).
|
6. |
Measure the coil resistance of the PCSV.
|
[EVAP. Leakage Test]
1. |
Select "Evap. Leakage Test".
|
2. |
Proceed with the test according to the screen introductions.
|
Giving voice commands
1. Press () on the steering wheel
remote control.
2. After the beep sounds, say "Help". All commands shall be listed which are
presented in active fields.
NOTE:
If the command is n ...
Side Airbag (SAB) Module. Repair procedures
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airba ...
To cancel cruise control, do one of the following
Depress the brake pedal.
Depress the clutch pedal if equpped with a manual transaxle.
Shift into N (Neutral) if equpped with an automatic transaxle.
Press the CANCEL switch located on the s ...