Inspection
1. |
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
|
2. |
Reconnect the PCV valve to the vapor hose.
|
3. |
Run the engine at idle, then put a finger over the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation, if operating
correctly clean or replace the vapor hose.
|
Front Impact Sensor (FIS). Repair procedures
Removal
•
Removal of the airbag must be performed according to the
precautions/ procedures d ...
Fog Lamps. Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lighting switch of the multifunction switch.
(Refer to the &q ...
Troubleshooting
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies ...