Hyundai Veloster Manuals

Hyundai Veloster: Rear Wiper Motor. Repair procedures - Rear Wiper/Washer - Body Electrical SystemHyundai Veloster: Rear Wiper Motor. Repair procedures

Inspection

Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 3 and 4 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.

No
Description
No
Description
1
Battery
3
Switch
2
Parking
4
Ground

Automatic Stop Operation Check
1.
Operate the motor at low speed using the speed control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 3.
3.
Connect terminals 2 and 3.
4.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 4.
5.
Check that the motor stops running at the off position.


Removal

1.
Detach the rear wiper head cap (A).

2.
Remove the rear wiper arm & blade (A) after removing rear wiper arm nut (B).

3.
Remove the rear wiper grommet.
4.
Open the tailgate then remove the tailgate trim.
(Refer to the BD group - "Tailgate")
5.
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts (3EA).


Installation

1.
Install the rear wiper motor assembly and the grommet.
Do not reuse the rubber pad if it is damaged.
2.
Install the tailgate trim.
(Refer to the BD group - "Tailgate")
3.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
4.
Set the rear washer nozzle on the specified spray position.

5.
Install the rear wiper cap and rear wiper nut.

Tightening torque Nut :
9.8 ~ 12.7 N.m (1.0 ~ 1.3 kgf.m, 7.24 ~ 9.38 lbf.ft)


Components and Components Location
Component Location 1. Rear wiper motor assembly 2. Rear wiper motor grommet 3. Rear wiper arm & blade 4. Nut ...

Rear Washer Switch. Repair procedures
Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch. Rear Wiper Switch ...

See also:

Front Driveshaft. Components and Components Location
Component location 1. Driveshaft (RH) 2. Driveshaft (LH) 3. Circlip Components [RH] 1. BJ assembly 2. Circlip ...

Impact sensing door unlock system
All doors will be automatically unlocked when the impact is delivered to impact sensors while the ignition switch is ON. However, the doors may not be unlocked if mechanical problems occur with th ...

Tailgate Glass. Components and Components Location
Components 1. Tail gate glass ...

Categories


В© 2011-2024 Copyright www.hvmanual.com