The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer.
- Normal wiper operation --- - Intermittent wipe O - Wiper is not in operation
Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever.
Overhead Console Lamp. Repair procedures
Inspection
1.
Remove the overhead console lamp (map lamp) assembly then check
for continuity between terminals. If the continuity is not as specified,
replace the map ...
Rail Pressure Sensor (RPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed. ...
Multimedia Jack. Schematic Diagrams
Circuit Diagram
...