Replacement
1. |
Remove the rear wheel & tire.
|
2. |
Remove the parking brake bracket (A).
|
3. |
Loosen the bolt and then remove the wheel speed sensor cable (A)
from the torsion beam axle.
|
4. |
Remove the brake caliper assembly (A) from the torsion beam axle
by loosening the bolts.
|
5. |
Loosen the bolt & nut and then remove the rear shock absorber
(A) from the torsion beam axle (B).
|
6. |
Remove the torsion beam axle (A) from the body loosening the bolts.
|
7. |
Remove the rear hub assembly.
(Refer to DS group - "Rear Axle")
|
8. |
Installation is the reverse of removal.
|
Specifications
Specifications
Item
Specification
Power source
DC 14.4V (-) ground
Frequency range
FM : 87.5 ~ 107.9 MHz / 200 kHz
...
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gentl ...
Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it
to reach normal operating temperature. 3. Turn the engine off and wait for a few
minutes (about 5 minutes) for the oil ...