Replacement
1. |
Remove the rear wheel & tire.
|
2. |
Remove the rear shock absorber (A) from the frame by loosening
the bolt.
|
3. |
Loosen the bolt & nut and then remove the rear shock absorber
(A) from the torsion beam axle (B).
|
4. |
Installation is the reverse of removal.
|
Inspection
1. |
Check the components for damage or deformation.
|
2. |
Compress and extend the piston and check that there is no abnormal
resistance or unusual sound during operation.
|
Capacity/weight
M/T : Manual transaxle A/T : Automatic transaxle DCT : Double clutch transmission ...
Antenna
Glass antenna (if equipped)
When the radio power switch is turned on while the ignition key is in either
the “ON” or “ACC” position, your car will receive both AM and FM broadcast signals ...
ESC OFF Switch. Repair procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer ...