Replacement
|
1. |
After loosening the mounting screws, then remove
the rear combination lamp (A).
|
2. |
Push the lock pin, disconnect the connector (B).
|
3. |
After loosening the rear bumper side’s mounting screw,
then disconnect the side’s.
|
4. |
Remove the rear bumper lower mounting clips.
|
5. |
Loosen the mounting bolts.
|
6. |
After loosening the mounting screw and clip, then
remove the rear bumper (A).
|
7. |
Push the lock pin, disconnect the rear bumper main
connector (A).
|
8. |
Installation is the reverse of removal.
|
Front Impact Sensor (FIS). Description and Operation
Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary pur ...
Brake Line. Repair procedures
Removal
1.
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cyl ...
Headlamp welcome function
When the headlight switch is in the ON or AUTO position and all doors (and tailgate)
are closed and locked, if you press the door unlock button on the transmitter (or
smart key), the headlights wi ...