Hyundai Veloster: Rear Glass Defogger Switch. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body Electrical System / Rear Glass Defogger / Rear Glass Defogger Switch. Repair procedures

Inspection

1.	The rear glass defogger switch inputs can be checked using the GDS.

2.	To check the input value of rear glass defogger switch, select option "Body Control Module".

3.	To consult the present input/output value of BCM, "Current DATA". It provides information of BCM input/output conditions of smart junction box.

4.	To check the input value of rear glass defogger switch in force mode, select option "Actuation Test of smart junction box".

Removal

1.	Disconnect the negative(-) battery terminal.

2.	Remove the center fascia panel assembly (A). (Refer to the Body group - "Crash pad")

3.	Remove the center fascia panel connector (A).

4.	Remove the heater and air corditioner controller (A), after loosening the screw (4EA).

Installation

1.	Install the heater and air conditioner controller to the center fascia panel.

2.	Install the center fascia panel assembly.

Rear Glass Defogger Printed Heater. Repair procedures

Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure ...

Windshield Wiper/Washer

...

See also:

Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise. Store the tire in the reverse order of removal. To prevent the spare tire and tools from “rattling” while the vehicle is in motion, store ...

Engine Control Module (ECM). Repair procedures
Removal When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

CVVT Oil Control Valve (OCV). Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated ...

Categories

© 2011-2024 Copyright www.hvmanual.com