Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the PCSV connector.
|
3. |
Measure resistance between the PCSV terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the purge control solenoid valve connector (A).
|
3. |
Disconnect the vapor hoses (B) from the purge control solenoid
valve.
|
4. |
Remove the valve after removing the bolt (C).
|
Installation
|
|
1. |
Installation is reverse of removal.
|
Components and Components Location
Components Location
1. Torsion beam axle
2. Shock absorber
3. Coil spring assembly
...
Repair procedures
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn ...
Fender. Repair procedures
Replacement
•
When removing and installing the fender,
an assistant is necessary.
...