Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
[Auto Down]
[Safety Up/Down]
|
4. |
Remove the grip holder cover after loosening 4 bolts.
|
5. |
Remove the grip holder bracket (A).
|
6. |
Remove the power window switch module (A) after loosening 4 screws.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
5. |
Remove the power window switch after loosening 2 screws.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
5. |
Remove the power window switch after loosening 2 screws.
|
Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid
should be checked on a regular basis, with the exact interval depending on the fluid.
Further details are provided i ...
Binding arbitration
Any claim or dispute you may have related to your vehicle's warranty or the duties
contemplated under the warranty, including claims related to the refund or partial
refund of your vehicle' ...
Wipers and washers
A :Wiper speed control (front) · 2 – High wiper speed · 1 – Low wiper speed ·
--- – Intermittent wipe · AUTO* – Automatic control wipe · O – Off ·
– Single wipe
B : Intermitte ...