Inspection
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the connector from the motor.
[Driver]
[Assistant]
|
3. |
Connect the motor terminals No.2 and No.3 directly to battery
voltage (12V) and connect the motor terminal No.4 to ground (0V).
Check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General Window]
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform
[NON-ISG]
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft
Position Sensor(CMPS) waveform at idle.The PCM controls the injection and igni ...
Fuel Filter. Repair procedures
Replacement
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel ...
All season tires
HYUNDAI specifies all season tires on some models to provide good performance
for use all year round, including snowy and icy road conditions. All season tires
are identified by ALL SEASON and/or ...