Inspection
1. |
With the lumbar support switch (A) in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the lumbar support switch.
|
Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the seat side cover (A).
(Refer to the BD group - "Front seat")
|
3. |
Remove the power seat control switch connector.
|
4. |
Remove the power seat control switch(A) after loosening the mounting
screw.
|
Installation
1. |
Connect the connector and install the power seat control switch.
|
2. |
Install the seat cover.
|
Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and
washer switch lever. Turn the switch to desired position to operate the rear wiper
and washer.
- Normal wiper oper ...
Hill-start assist control (HAC)
A vehicle has the tendency to slip back on a steep hill when the driver begins
to accelerate after a stop. The Hill-start Assist Control (HAC) prevents the vehicle
from slipping back by operating ...
Canister Close Valve (CCV). Schematic Diagrams
Circuit Diagram
...