Inspection
1. |
Remove the front door trim.
(Refer to the BD group - "Front door")
|
2. |
Remove the front door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate trim panel.
(Refer to the BD group - "Tailgate")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Remove the front door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear door module.
|
3. |
Disconnect the 7P connector from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Remove the tailgate trim.
(Refer to the BD group - "Tailgate")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check for continuity between the terminals in each switch position
according to the table.
|
Ignition switch position
LOCK
The steering wheel locks to protect against theft (if equipped). The ignition
key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the k ...
Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the
shift lever to the P(Park) pos ...
SRS Control Module (SRSCM). Description and Operation
Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that d ...