Hyundai Veloster: Parts
When replacing parts, use HYUNDAI genuine parts.
Replacement
Standard values, such as torques and certain adjustments, must be strictly
observed in the reassembly of all parts.
If removed, the following parts should always be replaced with new ones.
| 1. |
Oil seals
|
| 2. |
Gaskets
|
| 3. |
O-rings
|
| 4. |
Lock washers
|
| 5. |
Cotter pins (split pins)
|
| 6. |
Plastic nuts
Depending on their location.
|
| 7. |
Sealant should be applied to gaskets.
|
| 8. |
Oil should be applied to the moving components of parts.
|
| 9. |
Specified oil or grease should be applied to the prescribed locations
(oil seals, etc) before assembly.
|
Adjustment
Use gauges and testers to adjust correctly the parts to standard values
correctly.
Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment are available
starting work.
Special Tools
Use special tools when they are required.
Removal Of Parts
First find the cause ...
Electrical System
1.
Be sure to disconnect the battery cable from the negative (-)
terminal of the battery.
2.
Never pull on the wires when disconnecting con ...
See also:
Seat belt precautions
WARNING
All occupants of the vehicle must wear their seat belts at all times. Seat
belts and child restraints reduce the risk of serious or fatal injuries for all
occupants in the event of a coll ...
Manual climate control system
To defog inside windshield
1. Select any fan speed except “0” position. 2. Select desired temperature.
3. Select the or
position. 4. The outside (fresh)
air will be selected automaticall ...
Knock Sensor (KS). Schematic Diagrams
Circuit Diagram
...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
© 2011-2024 Copyright www.hvmanual.com