Removal
1. |
Remove the rear bumper.
(Refer to the Body group - "Rear bumper")
|
2. |
Disconnect the connector from the rear bumper.
|
3. |
Disconnect the connector(B) from the rear ultra sensor(A).
|
4. |
Pull out the sensor (A) by opening the sensor holder (C) out.
|
Installation
1. |
Install the rear ultra sensor after connecting the connector.
|
2. |
Install the rear bumper.
|
Giving voice commands
1. Press () on the steering wheel
remote control.
2. After the beep sounds, say "Help". All commands shall be listed which are
presented in active fields.
NOTE:
If the command is n ...
Identification Number Description
Vehicle Identification Number
1.
World Manufacturer Identifier (WMI)
A.
KMF : Commercial vehicle (Van)
B.
...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
: For a single wiping cycle, move
the lever to this position and release it. The wipers will operate continuously
if the lever is held i ...