Hyundai Veloster Manuals

Hyundai Veloster: Measurement Point - General InformationHyundai Veloster: Measurement Point

Measurements should be taken at the center of the hole.

Checking Cables And Wires

Measuring Actual Dimensions
1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

Checking Cables And Wires
1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

See also:

Brake Booster. Repair procedures
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop ...

Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, closed, or tilted wh ...

DCT Control Modle (TCM) > Description and Operation
Description The Transmission Control Module (TCM) is like the brain for the DCT. It receives information from various sensors for a wide range of transmission controls to provide an optimal ...

Categories


В© 2011-2025 Copyright www.hvmanual.com