Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the battery (A) and ECM (B).
(Refer to the Engine Electrical group - "Battery")
|
3. |
Disconnect the brake fluid level switch connector (A) from the
reservoir.
|
4. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
5. |
Disconnect the brake tube from the master cylinder by loosening
the tube flare nut (A).
|
6. |
Remove the clutch hose (B). [MT Only]
|
7. |
Remove the master cylinder (B) from the brake booster after loosening
the mounting nuts (C).
|
Installation
1. |
Installation is the reverse of removal.
|
2. |
After installation, bleed the
(Refer to Brake system bleeding)
|
Refrigerant label
The refrigerant label is located on the underside of the hood. ...
Highway driving
Tires
Adjust the tire inflation pressures to specification. Low tire inflation pressures
will result in overheating and possible failure of the tires.
Avoid using worn or damaged tires which may ...
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, ...