Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Installation
|
|
1. |
Installation is reverse of removal.
|
AVN Remote Control. Schematic Diagrams
Circuit Diagram
...
If the engine will not start
If engine doesn't turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in
N (Neutral) or P (Park) and the emergency brake is set. 2. Check th ...
Components and Components Location
Components(1)
Connector name
No
Descripton
Connector name
No
RH SIDE
Lighting
(13 pin)
-LH side
...